Tools
None: the screws turn in by hand.
Parts (5)
| Part | Count | Size | Goes in | Note |
|---|---|---|---|---|
| Tabletop | 1 | 55 × 55 × 5 cm | step 2 | The big square board. The four pre-drilled holes are in the corners of the underside. |
| Leg | 4 | 40 × 5 × 5 cm | step 3 | One of four identical square legs. The end with the small hole goes onto the screw. |
Hardware (4 pieces)
| Part no. | Hardware | Count | Size | Used in |
|---|---|---|---|---|
| 115980 | Double-ended screw | ×4 | Ø 6 × 70 mm | step 2 |
Sizes are as drawn in the 3D: diameter × length for fasteners, in millimeters.
The 3 steps
-
Step 1: Check your parts on a soft surface
Lay a rug, a blanket or the flattened box on the floor and put everything on it. You should have one tabletop, four legs and four double-ended screws.
Watch out: Do not build on a bare hard floor. The manual shows the tabletop getting scratched and dented that way.
-
Step 2: Turn the screws into the tabletop
Lay the tabletop face down on the soft surface. Turn one double-ended screw clockwise by hand into each of the four corner holes, until the collar in the middle of the screw meets the board.
Watch out: Keep each screw straight as you turn it. A crooked screw makes the leg stand at an angle.
Tip: Only half of each screw goes into the top. The other half holds the leg.
-
Step 3: Screw on the four legs
Set a leg on each screw, hole end first, and turn the leg clockwise until it sits tight against the tabletop. Then turn the table onto its legs.
Watch out: Stop when the leg meets the top. Forcing it further can strip the hole and leave the leg loose.
