Tools

None: the screws turn in by hand.

Parts (5)

PartCountSizeGoes inNote
Tabletop155 × 55 × 5 cmstep 2The big square board. The four pre-drilled holes are in the corners of the underside.
Leg440 × 5 × 5 cmstep 3One of four identical square legs. The end with the small hole goes onto the screw.

Hardware (4 pieces)

Part no.HardwareCountSizeUsed in
115980Double-ended screw×4Ø 6 × 70 mmstep 2

Sizes are as drawn in the 3D: diameter × length for fasteners, in millimeters.

The 3 steps

  1. Step 1: Check your parts on a soft surface

    2 min

    Lay a rug, a blanket or the flattened box on the floor and put everything on it. You should have one tabletop, four legs and four double-ended screws.

    Watch out: Do not build on a bare hard floor. The manual shows the tabletop getting scratched and dented that way.

  2. Step 2: Turn the screws into the tabletop

    3 min · Double-ended screw 115980 ×4

    Lay the tabletop face down on the soft surface. Turn one double-ended screw clockwise by hand into each of the four corner holes, until the collar in the middle of the screw meets the board.

    Watch out: Keep each screw straight as you turn it. A crooked screw makes the leg stand at an angle.

    Tip: Only half of each screw goes into the top. The other half holds the leg.

  3. Step 3: Screw on the four legs

    5 min

    Set a leg on each screw, hole end first, and turn the leg clockwise until it sits tight against the tabletop. Then turn the table onto its legs.

    Watch out: Stop when the leg meets the top. Forcing it further can strip the hole and leave the leg loose.