Before you start

In the app this list is a gate: the first step does not play until every line is ticked.

  1. Turn the disposer's power switch off before you clear a jam, remove an object or press the reset button.
  2. Never put fingers or hands into the disposer. Use the wrenchette for a jam and long-handled tongs or pliers for objects.
  3. Take the wrenchette out before you turn the disposer back on.

Tools

  • Self-service wrenchette (H), step 3
  • Long-handled tongs or pliers, step 4

Parts (4)

PartCountSizeGoes inNote
Disposer body1Ø 16 × 24 cmstep 2The big dark body that hangs under the sink; the jam is inside it.
Sink mount and flange1Ø 17 × 4.6 cmstep 2The metal ring on top that holds the disposer to the sink; it stays in place for this job.
Center hole (wrenchette socket)1Ø 1 × 0.6 cmstep 2The hole in the exact center of the bottom; the wrenchette fits here.
Red reset button1Ø 1.5 × 0.6 cmstep 2The red button off to one side of the bottom, not in the center like the wrenchette hole.

The 5 steps

  1. Step 1: Get your wrenchette and tongs ready

    1 min

    Find the wrenchette (H) that came with the disposer and a pair of long-handled tongs or pliers. The jam is cleared from the bottom of the disposer, under the sink.

    Tip: The center hole and the red reset button are both on the bottom of the disposer. A flashlight helps you see them.

  2. Step 2: Turn off the disposer and the water

    1 min

    If the motor stopped while running, the disposer may be jammed. Turn the disposer switch off and turn off the water at the faucet.

    Watch out: Turn the power switch to the off position before you clear a jam, remove an object from the disposer or press the reset button.

  3. Step 3: Turn the center hole with the wrenchette

    3 min · Self-service wrenchette (H)

    Push one end of the wrenchette into the center hole on the bottom of the disposer. Work it back and forth until it turns one full revolution, then pull the wrenchette out.

    Watch out: Remove the wrenchette before you reconnect power. Never hold the wrenchette while the disposer runs; it can cause broken bones or cuts.

    Tip: Short back-and-forth turns free a jam better than one hard push. Keep going until it spins a full turn easily.

  4. Step 4: Remove the object and press reset

    7 min · Long-handled tongs or pliers

    From the sink opening, reach in with tongs and pull out what jammed it. Let the motor cool for 3 to 5 minutes, then lightly push the red reset button on the bottom of the disposer.

    Watch out: Do not put fingers or hands into the disposer, even with it switched off. Use long-handled tongs or pliers.

    Tip: Press the reset button lightly. It sits off to one side of the bottom, away from the center hole.

  5. Step 5: Test run with cold water

    2 min

    Check the wrenchette is out of the bottom. Run cold water first, then turn on the disposer. If the motor still will not run, check your service panel for a tripped circuit breaker or a blown fuse.

    Watch out: Keep fingers and hands out of the disposer while it runs. Use cold water, not hot, when you grind food waste.