Tools

None: a sink, a bin and running tap water.

Parts (5)

PartCountSizeGoes inNote
Main body (motor and screen)120 × 12 × 11 cmstep 2The middle of the machine with the screen. The filter twists off its rear end.
Handle with trigger1Ø 4 × 13 cmstep 2The grip under the main body. Keep your finger off the trigger while you work.
Click-in battery116 × 7 × 5 cmstep 2The flat base under the handle. It stays on the machine for this job.
Clear bin1Ø 10 × 18 cmstep 2The clear bin at the front with the MAX line. Not the filter: the filter is at the opposite end.
Filter1Ø 8.5 × 8 cmstep 8The round filter at the rear of the machine. It has a hard plastic end and a pleated end, and it is the only part you wash.

The 9 steps

  1. Step 1: Get your machine and a sink ready

    1 min

    Lift your V15 off its dock or charger and set it on a table near a sink and a bin. The filter is the round part at the rear of the machine, at the screen end.

    Tip: Wash your filter at least once a month to keep full suction power.

  2. Step 2: Twist off your filter

    1 min

    Hold the machine by the handle and twist the filter at the rear anti-clockwise. Then pull it straight away from the machine.

    Tip: Keep your finger off the trigger while you hold the handle.

  3. Step 3: Tap out the loose dust

    1 min

    Hold the filter by its hard plastic end and tap the other end gently over a bin. This knocks out loose dust and debris before you wash it.

  4. Step 4: Wash it under the tap

    3 min

    Hold the filter under warm running tap water. Rub it gently with your fingers to lift the dirt out.

    Tip: Use water only. The manual says not to use detergents on your machine.

  5. Step 5: Fill the filter and shake

    2 min

    Cover one end of the filter with your hand and fill it with warm tap water through the other end. Put your hand over the open end and shake it firmly to loosen trapped dirt.

    Tip: The manual shows the wider end resting in your palm and the water going into the narrower end.

  6. Step 6: Shake out the water

    2 min

    Empty the filter and shake it firmly, first pointing up and then pointing down. Keep shaking until no more water comes out.

  7. Step 7: Leave it to dry for 24 hours

    1 min

    Stand the filter with the pleated end facing up in a warm, well-ventilated place. Leave it to dry for at least 24 hours.

    Watch out: Don't dry your filter in a tumble dryer, microwave or near a naked flame.

    Tip: The minute here is for setting it down. The 24-hour wait comes on top.

  8. Step 8: Refit the dry filter

    1 min

    Check that the filter is completely dry. Push it onto the rear of the machine and twist it clockwise until it is firmly in place.

    Watch out: Your filter must be completely dry before you put it back. Your machine could be damaged if used with a damp filter.

    Tip: The manual only shows removal. Refitting is the reverse: push on, then twist clockwise.

  9. Step 9: Check the screen for a filter alert

    1 min

    Switch the machine on briefly and watch the screen. If it shows Filter not sealed, twist the filter off and refit it until it sits firmly.

    Watch out: A Filter not sealed alert means the filter isn't fitted correctly. Don't keep cleaning until the alert is gone.